What is the Size of A3 Paper in mm (As per Indian Standard)
A3 - 420x297 A4 - 297x210
Which of the following lines are used to show that the object is cut and then viewed
Hatching to show highlighted area.
The default position of the UCS icon is at on AutoCAD grid
zero origin
Which command allow you to make a rectangle or square
REC - for Rectangle (square is also rectange with same dimensions)
Which file type is an AutoCAD backup file?
for Drawing file - DWG for Backup file - BAK for drawing exchange format - DXF
What keyboard key is used for Ortho on/off?
F8 key for Ortho. Ortho means drawing lines on 90degree. (i.e. horizonatal and vertical only). F1 - Display Help F2 - Text Screen F3 - Object Snap F4 - 3D Snap F5 - Isoplane. F6 - Dynamics UCS. F7 - Grid Mode. F8 - Ortho Mode. F9 - Snap Mode. F10 - Polar. F11 - Oject Snap Tracking. F12 - Dynamic Input.
How many point do you need to define for the rectangle command
Two Opposite corner of rectangle.
Scaling object makes them
One of the below options is wrong about type of Autocad drawing units which one is it
Total 5 unit types in Autocad. 1. Architectural 2. Decimal 3. Engineering 4. Fractional 5. Scientific Millimeter is a sub-unit of Decimal type (metric). ... Angle units 1. Decimal Degree 2. Degree 3. Gradient 4. Radian 5. Surface unit
Which command used to determine area
AA - Area. A - Arc
In AutoCAD all object are drawn on the?
XYZ PLANE FOR 3D
All of the following object can be extruded except
Polyline can be extruded by closing polyline like adding 4 5 closed lines. Same as close traverse. Arc can't be extruded without adding shell deformer (depth)
When the keyboard F9 is pressed the following facility is logged on/off
F1 - Display Help F2 - Text Screen F3 - Object Snap F4 - 3D Snap F5 - Isoplane. F6 - Dynamics UCS. F7 - Grid Mode. F8 - Ortho Mode. F9 - Snap Mode. F10 - Polar. F11 - Oject Snap Tracking. F12 - Dynamic Input.
What does WCS stand for
UCS - user co-ordinate system.
The fillet command creates
Fillet- Round Corner. CHAmfer - Sharp corner.
What keyboard key is used for polar on/off ?
F1 - Display Help F2 - Text Screen F3 - Object Snap F4 - 3D Snap F5 - Isoplane. F6 - Dynamics UCS. F7 - Grid Mode. F8 - Ortho Mode. F9 - Snap Mode. F10 - Polar. F11 - Oject Snap Tracking. F12 - Dynamic Input.
What command allow you to change linetype scale
LT -LineTye. LTS - LineTypeScale
When drawing in 2D, what Axis do you not work with
2D- XY. 3D- XYZ
What is the minimum allowable number of layers in drawing?
How many snap points does an object have
Snap Points. Circle - 5. Rectange - 9
Share your Results: